User`s guide

Troubleshooting 8-21
The server is not found on the network:
 Is the LAN cable connected?
→ Make sure to connect the LAN cable to the network port on the rear of the server. Also make sure that the
LAN cable to use conforms with the network interface standard.
 Is BIOS configuration correct?
→ The internal LAN controller may be disabled with the BIOS SETUP utility of the server. Check the setting
with the BIOS SETUP utility.
<Menus to check:
[Advanced] - [PCI Configuration] - [Onboard LAN] - [LAN Controller]>
 Have the protocol and service already configured?
→ Install the distinctive network driver for the server. Make sure that the protocol, such as TCP/IP, and services
are properly specified.
 Is the transfer speed correct?
→ Open the network property dialog box in control panel to specify the "Link Speed & Duplex" value the same
as the value specified for HUB.
Wake on LAN does not start from standby or paused state.
→ WOL (Wake On LAN) is not available while the system is in standby or paused state.