User`s guide

8-12 Troubleshooting
Error Messages on Virtual LCD
NEC EXPRESSSCOPE Engine 2 (Remote Management Controller) on your server board allows you to monitor the server
status on the WEB browser-based screen of the client PC via network.
The virtual LCD (16 digits x 2 lines) in the "Host Information" area displays the POST codes and status message.
When POST detects an error, the POST error code is displayed on the virtual LCD upon completion of POST. See the table
below for POST error codes for details.
POWER ON
ATTENTION
Virtual LCD
Status indicators
Message send from BIOS
Message send from BMC
Example:
Messages displayed on upper line (BIOS message)
On-screen message Description Action
XX BIOS Rev YYYY
POST in progress.
XX: POST code, YYYY: BIOS version
This is not an error.
Mem Reconfigured
POST completes with memory
degraded.
Contact your service
representative.
Try the following steps to cancel
the error.
1. Start BIOS SETUP.
2. Select [Advanced] - [Memory
Configuration] - [Memory
Retest] - [Yes].
3. Select [Exit] - [Exit Saving
Changes].
Memory C-Err XX
A correctable error frequently occurs
in DIMM #XX.
PCI Bus PERR XX
A PERR has occurred in the PCI bus
XX.
PCI Bus SERR XX
A SERR has occurred in the PCI bus
XX.
Mem Err Disable
A correctable memory error frequently
occurred.
Contact your service
representative.
Prepare To Boot POST completes normally. This is not an error.