User`s guide

8-6 Troubleshooting
Error
code
Error message Recommended Action
0B71 System Temperature out of the range. Contact your service representative to
replace the fan.
0B74 The error occurred during voltage sensor
reading.
0B75 System voltage out of the range.
Contact your service representative.
0B80 BMC Memory Test Failed.
0B81 BMC Firmware Code Area CRC check
failed.
0B82 BMC Core Hardware failure.
0B83 BMC IBF or OBF check failed.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
0B8A BMC SEL area full. Start the SETUP and select [Server] -
[Event Log configuration] - [Clear All Error
Logs] and press Enter to clear event logs.
0B8B BMC progress check timeout.
0B8C BMC command access failed.
0B8D Could not redirect the console - BMC Busy -
0B8E Could not redirect the console - BMC Error -
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
0B8F
Could not redirect the console - BMC
Parameter Error -
0B90 BMC Platform Information Area corrupted.
0B91 BMC update firmware corrupted.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
0B92 Internal Use Area of BMC FRU corrupted.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
0B93 BMC SDR Repository empty.
Turn off the power once and then on again
to restart the server. If the error cannot be
corrected, contact your service
representative.
0B94 IPMB signal lines do not respond.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
0B95 BMC FRU device failure.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
0B9A BMC not responding.
Update the RMC firmware. If the error
cannot be corrected, contact your service
representative.