User`s guide

Installing the Operating System with Express Setup 5-73
Installation of Mass storage device not supported by Express Setup
If you want to install or re-install the OS when the system has a new mass storage device not supported by ExpressBuilder, do
as follows.
1. Read the manual supplied with the mass storage device before setting the server.
2. If the mass storage device is managed by a RAID Controller, configure the RAID System before running the
ExpressBuilder.
3. Boot the system from the ExpressBuilder DVD.
4. Select [Load the optional driver into the ExpressBuilder] from the Top menu, click [Next].
Insert the driver disk for the mass storage controller. Press the "Perform" button.
NOTE: By choosing this option, you can load the driver provided by the CD-ROM or floppy
disk to proceed with the Express Setup.
5. Perform Express Setup with the following settings.
(a) When "Enter RAID settings" appears, check "Skip the logical drive creation".
(b) Select "Apply OEM-Disk for Mass storage device".
6. Copy the driver for the mass storage device in the Express Setup.
Insert the floppy disk attached to the mass storage device into the floppy disk drive.
Continue the Express Setup, referring to messages displayed on the display.