User`s guide

5-72 Installing the Operating System with Express Setup
Installing with the OEM-Disk for Mass Storage Device
This section explains how to set up with the OEM-Disk. You usually do not have to do as follows (not a standard procedure).
The detailed information is provided by the manual of the Mass storage device.
Creating a new RAID using the RAID Controller
If you create a new RAID using the RAID Controller, create a RAID as follows before installing Windows Server 2008.
If you do not need to create a new RAID, this procedure is not required.
Creating RAID using [ExpressBuilder].
1.
Boot from the ExpressBuilder DVD.
2. Select [Perform the Express setup] from the Top Menu, click [Next].
3. When the [Load parameters] screen is displayed, if you do not need to load parameters, select [Do not load
parameters] and click [Next].
4. Select [Install other Operating System] at [Select OS] steps, and then click [Next].
5. Select [Create a logical drive using the settings that follow] at [Enter RAID settings] steps.
Confirm the parameters, modify if necessary, and then click [Next].
6. Save parameters at [Save parameters] steps.
If you do not need to save parameters, select [Do not save parameters], and click [Next].
7. Click [Perform] at [Configuring RAID] steps.
RAID configuration is started.
8. When [Exit ExpressBuilder] screen is displayed, click [Perform] again.
The system reboots.
Reboot from the ExpressBuilder DVD, and then perform Express Setup referring to [Installing the Operating System
with Express Setup].
NOTE: When you start Express Setup, select [Skip the logical drive creation] at Step 4 [Enter
RAID settings] screen.