User`s guide

5-60 Installing the Operating System with Express Setup
9. On the [Paging file size for each drive] box, specify as follows:
– A value larger than the recommended size shown
in [Total paging file size for all drives] for [Initial
size]
– A value larger than the [Initial size] for
[Maximum size]
Then click [Set].
IMPORTANT:
 The above-mentioned paging file size is recommended for collecting debug information
(memory dump). A paging file with an initial size large enough to store the dump file in the
boot drive is required.
Correct debug information might not be collected due to a virtual memory shortage when the
paging file is insufficient, so set a paging file size large enough for the entire system..
 For more information on "Recommended" value, see "About the System Partition Size"
described earlier.
 If the memory is expanded, re-specify the paging file to suit the new memory size.
10. Click [OK].
The message to restart the system may appear according to the modified specification.
In such case, restart the system.