User`s guide

5-22 Installing the Operating System with Express Setup
Installing and Setting Device Drivers
Follow these steps to install and configure the device drivers.
LAN Driver and PROSet
The LAN driver and PROSet have been installed automatically while your system was being updated as described in the
previous section.
NOTE: To change the LAN driver and PROSet settings, log on to the system from a local
console using an administrator account. Remotely changing the settings by using the operating
system’s remote desktop feature is not supported.
Using the Intel Pro/1000 PT Server Adapter after System Update
To use the Intel Pro/1000 PT server Adapter after updating your system, you must first uninstall the LAN driver and PROSet,
and then update your system with the Intel Pro/1000 PT server Adapter connected.
For a server running a full installation
1.
Remove a team of network adapters.
NOTE: Before you remove, note down the current settings (e.g. IP addresses) of the standard and
optional adapters teamed for network redundancy.
Configure the settings after reinstalling the LAN driver and PROSet.
To remove the team, see "Adapter Fault Tolerance (AFT)/AdaptiveLoad Balancing (ALB)".
2. In [Control Panel], click [Uninstall Program].
3. Double-click [Intel(R) Network Connections 13.2.8.0].
[Intel(R) Network Connections (Remove Options)] appears.
4. In [Remove Options], click [Remove].
[Intel(R) Network Connections - Remove Software] appears.
5. Select [Yes].
The uninstallation starts automatically.
6. When [InstallShield Wizard Completed] appears. Click [Finish].
Restart the system.
For a server running a Server Core installation
1.
Note down the current settings (e.g. IP addresses) of the standard and optional adapters teamed for network
redundancy before uninstalling the LAN driver.
Configure the settings after reinstalling the LAN driver.
2. At a command prompt, run dxsetup.exe in your removable medium containing the Driver Set.
– Windows Server 2008 64-bit (x64) Editions:
<drive letter>:\009\win\winnt\ws2008x64\ma21\apps\prosetdx\vistax64\dxsetup.exe
– Windows Server 2008 32-bit (x86) Editions:
<drive letter>:\009\win\winnt\ws2008\ma21\apps\prosetdx\vista32\dxsetup.exe
3. In [Intel(R) Network Connections - InstallShield Wizard], click [Next].