User`s guide

4-104 Configuring Your Server
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" as described in Chapter 9 of this guide.
2. Remove the top cover (see Chapter 9).
3. Locate the position of the jumpers on the mother board.
Refer to the previous illustration to find the location of the jumper.
4. Move the jumper cap to the CMOS clear position.
5. Wait for a while (about 5 seconds), and then reinstall the jumper cap to the default position.
6. Reinstall the top cover removed in Step 2.
7. Plug the power cord to your server and turn on the server.
8. Press F2 at the prompt to run the BIOS SETUP utility, and select "Load Setup Defaults" at the Exit menu.
Clearing Password
1.
See the section "Preparing for Installation and Removal" as described in Chapter 9 of this guide.
2. Remove the top cover (see Chapter 9).
3. Locate the position of the jumpers on the mother board.
Refer to the previous illustration to find the location of the jumper.
4. Move the jumper cap to the password clear position.
5. Reassemble the server, and press the POWER switch to turn on the server.
6. Press F2 during POST to run the BIOS Setup utility, set the password again, and select [Exit Saving Changes].
7. Power off the server, and move the jumper cap to the password protect position.
8. Reassemble the server.