User`s guide

Configuring Your Server 4-77
Configuring SPAN
The following section explains the sample procedure to configure RAID10 (spanning of RAID1) with four Hard Disk Drives.
IMPORTANT: Do not attempt to configure RAID00 or RAID60. They are not supported.
1. Click [Configuration Wizard] on the WebBIOS Top Menu to start Wizard.
2. While pressing Ctrl, click the Hard Disk Drives to be included in the DG.
(In the example, two DGs will be configured and spanned.)
3. Once selected, click [Add to Array] at the lower left of the screen. After making sure that the new DG has been
defined in the Drive Groups frame (right column), click [Accept DG].