User`s guide

4-32 Configuring Your Server
Menu Tree
+: Selection/execution parameter : Setting parameter. •: Information display
>: Can be set (modified) after creation of virtual drive
Menu Description
+Configure Performs Configuration settings
+Easy Configuration Set configuration (Using fixed value)
+New Configuration Set new configuration
+View/Add Configuration Additional setting / viewing configuration
+Clear Configuration Clear configuration
+Select Boot Drive Chose Bootable Virtual Drive
+Initialize Initialize virtual drive
+Objects Various settings
+Adapter Set disk array controller
+Sel. Adapter Clear configuration
Rebuild Rate 30
Chk Const Rate 30
FGI Rate 30
BGI Rate 30
Disk WC Off
Read Ahead On
Bios State Enable
Cont on Error Yes
Fast Init Enable
Auto Rebuild On
Auto Resume Enable
Disk Coercion 1GB
Factory Default
+Virtual Drive Virtual drive operation
+Virtual Drives Select virtual drive (when multiple virtual drives exist)
+Initialize Initialize virtual drive
+Check Consistency Check virtual drive redundancy
+View/Update Parameters Display virtual drive information
• RAID Display RAID level
• SIZE Display virtual drive capacity
• Stripe SIZE Display stripe size
• #Stripes Display the number of hard disk drives in virtual drive
• State Display virtual drive status
• Spans
• Disk WC Off: Write through
On: Write back
• Read Ahead
+Physical Drive Physical drive operation
+Physical Drive Selection Menu Select physical drive
+Make HotSpare Set as hot-spare disk for auto rebuilding
+Force Online Make a disk online
+Change Drv State Make a disk offline or make a hot-spare ready
+Drive Properties Display hard disk drive information
• Device Type Hard disk drive type
• Capacity Hard disk drive capacity
• Product ID Hard disk drive model
• Revision No. Hard disk drive revision
+Rebuild Perform rebuilding
+Check Consistency Perform virtual drive redundancy check
Operating Procedures for Configuration Utility
Creating/Adding Configuration
Run LSI Software RAID Configuration Utility
Set new configuration information (pack/virtual drive settings)
Check the virtual drive settings