User`s guide
Chapter 5: Advanced Serverboard Setup
5-35
Power Setting Select
JPEN1 allows you to con gure power settings for
hot-swap support on the Hot-Swap version of Chas-
sis 827. To enable hot-swap support for this model of
chassis, connect a cable to Pins 2~3 of JPEN1. To
use the regular power setting for other chassis, close
Pins 1~2 on JPEN1 with a cap. See the table on the
right for jumper settings.
Power Setting Select
Jumper Settings
Jumper Denition
Pins 1-2 Onboard PWR
setting
Pins 2-3 Hot Swap support
A: PWR Setting Select
B: VGA Enable
VGA Enable
JPG1 allows you to enable or disable the onboard
VGA connection supported by the onboard VGA Con-
troller. The default position is on pins 1 and 2 to enable
VGA. See the table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Both Jumpers Denition
Pins 1-2 Enabled
Pins 2-3 Disabled