User`s guide
Advanced Serverboard Setup 5-19
Chassis Intrusion
The Chassis Intrusion header is
designated JL1. See the board layout
for the location of JL1 and the table on
the right for pin defi nitions.
Universal Serial Bus (USB)
There are two Universal Serial Bus
ports located on the I/O panel and
two additional USB headers located on
the serverboard. The headers, labeled
USB2 and USB3, can be used to
provide front side USB access (cables
not included). See the tables on the
right for pin defi nitions.
LAN1/2 (Ethernet Ports)
Two gigabit Ethernet ports (designated
LAN1 and LAN2) are located beside
the VGA port on the I/O backplane.
These ports accept RJ45 type cables.
Wake-On-LAN
The Wake-On-LAN header is
designated JWOL on the serverboard.
See the table on the right for pin
defi nitions. You must enable the LAN
Wake-Up setting in BIOS to use this
function. (You must also have a LAN
card with a Wake-On-LAN connector
and cable to use this feature.)
Chassis Intrusion
Pin Defi nitions (JL1)
Pin# Defi nition
1 Intrusion Input
2 Ground
USB Ports Pin
Defi nitions (USB0/1)
Pin# Defi nition
1 +5V
2 PO-
3 PO+
4 Ground
5 N/A
USB Headers
Pin Defi nitions (USB1, USB2)
USB3/5
Pin # Defi nition
USB2/4
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 Key 5 No connection
LAN1 LAN2
Wake-On-LAN
Pin Defi nitions (JWOL)
Pin# Defi nition
1 +5V Standby
2 Ground
3 Wake-up