User`s guide

System Speciﬁ cations and Regulatory Information E-5

EC Conformity

- 93/68/EEC

Telecommunications Terminal Equipment

- 199/5/EC

Neither the provider nor the manufacturer can accept responsibility for any failure to satisfy

the protection requirements resulting from a non–recommended modiﬁ cation of the product.

Compliance with these directives requires:

- An EC declaration of conformity from the manufacturer

- An EC label on the product

- Technical documentation

International Electrotechnical Commission (IEC) Statement

This product has been designed and built to comply with standard IEC 60950.

Federal Communications Commission (FCC) Statement

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the user will be required to correct

the interference at its own expense.

Properly shielded and grounded cables and connectors must be used in order to meet FCC

emission limits. Neither the provider nor the manufacturer is responsible for any radio or

television interference caused by using other than recommended cables and connectors

or by unauthorized changes or modiﬁ cations to this equipment. Unauthorized changes or

modiﬁ cations could void the user’s authority to operate the equipment.

Any changes or modiﬁ cations not expressly approved by the grantee of this device could

void the user’s authority to operate the equipment. The customer is responsible for ensuring

compliance of the modiﬁ ed product.