Installation guide

22 NovaScale Master 5.2-x Server Add-ons - Installation and Administrator's Guide
3.1.3.1 Default Categories & Services (independent of OS type)
Targeted OS
Model Category Service Check command
Any Any MegaRaidSAS Status check_MegaRAIDSAS
Alerts No check (SNMP trap
receiver)
Any Any MegaRaidSAS_IR Status check_MegaRAIDSAS_IR
Alerts No check (SNMP trap
receiver)
Table 3-3. MegaRaid SAS (IR) monitoring services
Note:
This category is based on the MegaRAID SAS (IR) SNMP agent. This SNMP interface is a
requirement for the following MegaRaidSAS(-IR) monitoring services.
3.1.3.2 MegaRaidSAS(_IR) Category
Status For NovaScale hosts with a MegaRAID SAS card or an integrated LSI SAS
chip managed by MegaRAID Storage Management tool. This service checks
the MegaRAID SAS (IR) status reported by the MegaRAID SAS (IR) SNMP
agent.
Alerts For NovaScale hosts with a MegaRAID SAS card or an integrated LSI SAS
chip. When an alert is sent from the MegaRAID SAS (IR) SNMP agent, it is
processed by the NovaScale Master Server.
Note:
The lsi-adaptersas(ir).mib mib is integrated in the NovaScale Master
application.
Note:
Do not forget to configure the MegaRAID SAS (IR) SNMP agent to send SNMP traps to the
NovaScale Master Server by adding the NovaScale Master Server host address to the agent’s
SNMP managers list.
3.1.3.3 check_MegaRaidSAS(_IR) (any OS) Nagios command
The configurable NovaScale Master service check command syntax is:
check_MegaRaidSAS(_IR)!<community>!<port>!<timeout>
See the check_ MegaRaidSAS(_IR) command in Appendix A for parameters details.
Default syntax for ”MegaRaidSAS(_IR).Status” is:
check_ MegaRaidSAS(_IR)!public!161!60