User`s guide

2-17
Getting Started
9. Click Return to index.
10.Click Log Out to exit Webmin.
11.Toggle the integrated console to the PAP unit port.
12.From the Customer Administrator PAM tree, click Configuration Tasks → Domains →
Identities to open the Identities page.
13.Select the corresponding Linux domain from the list and click Edit to open the Edit an
Identity dialog.
14.Check that the Network Name, IP Address, and URL fields are completed. If not, complete
these fields with the networking data entered during the Linux setup completion procedure
and click OK.
Linux SuSE Domain
1. Toggle the integrated console to the corresponding Linux domain port. See Toggling the
Local / Integrated Console Display, on page 2-9.
2. From the Linux desktop, enable remote connection via telnet, rlogin, ftp, ...:
3. Launch the yast2 command to open the Yast Control Center screen.
4. Click the Network/Basic icon in the left pane.
5. Click Start/stop services (inetd).
6. From the Network Services page, select On with customer configuration and click Next to
open the Enable/disable network services page.
7. From the service list, check that Active is displayed in the status column. Proceed as
follows to enable the service:
a. Select the required service from the list.
b. Click Activate.
8. Repeat step 5 for each required service.
9. Click Finish to apply all changes.
10.Click Close to exit yast2.
11.Toggle the integrated console to the PAP unit port.
12.From the Customer Administrator PAM tree, click Configuration Tasks → Domains →
Identities to open the Identities page.
13.Select the corresponding Windows domain from the list and click Edit to open the Edit an
Identity dialog.
14.Check that the Network Name, IP Address, and URL fields are completed. If not, complete
these fields with the networking data entered during the Linux setup completion procedure
and click OK.