User`s guide

5-63
Tips and Features for Administrators
Renaming LUNs
Important:
Reserved for systems connected to a Storage Area Network (SAN).
Please contact your Bull Sales Representative for sales information.
Note:
A LUN CANNOT be renamed if it is allocated to a Scheme.
To rename a LUN:
1. Click Configuration Tasks → Domains → LUNs in the PAM tree to open the Logical Units
page.
2. Select the LUN you want to rename from the lists of available LUNs and click Rename
LUN to open the Rename LUN dialog.
Figure 125.Rename LUN dialog
3. Enter the new name and click OK to apply the change.
Clearing, Loading, Saving NVRAM Variables
NVRAM variables are available for each EFI boot LUN. According to requirements, these
variables can be cleared, saved and/or loaded.
Note:
NVRAM variables can only be saved when the corresponding domain is active.
To clear, save and/or load NVRAM variables:
1. Click Configuration Tasks → Domains → LUNs in the PAM tree to open the Logical Units
page.
2. Select the required LUN from the list of available EFI boot LUNs and click NVRAM. The
NVRAM Variables dialog opens:
a. Click Clear to clear displayed NVRAM variables. When requested, click OK to
confirm.
b. Click Save to save NVRAM variables for the selected LUN (currently used by an active
domain). When requested, enter the name of the file to which NVRAM variables are
to be saved. The NVRAM variables file is stored in the PAM SiteData directory.
c. Click Load to load previously saved NVRAM variables from the PAM SiteData
directory.