Installation guide

2-45
Setup Procedure
Connecting the USB Modem and External Devices
Connecting the USB Modem
If the Customer's maintenance contract includes the Autocall feature, connect the USB modem
as follows:
1. Connect the modem cable equipped with a USB connector to the USB port on the rear of
the PAP unit.
2. Route the line modem cable equipped with an RJ11 connector through the cable cut-out at
the base of the cabinet.
3. Connect the modem cable to the line port on the rear of the USB modem.
See the Cabling Guide, 86 A192ER.
Note:
Modem cable connectors differ from country to country. Customers are to provide the RJ11
adapter required to comply with national standards.
Connecting External Storage Peripherals
The Customer may now proceed to connect any external storage peripherals (tape libraries,
external disk subsystems, ...) required for use with the server.