Installation guide

2-6
Installation Guide
Checking Server Operation
Once the server has been installed and powered up, correct operation must be checked.
Important:
The server must be fully checked with factory default data.
See the Read Me First booklet delivered with the system 24 hours before the
scheduled installation date for factory default data.
Launching PAM Software
The server is equipped with an integrated Platform Administration and Maintenance software
package, otherwise known as PAM software.
One part of PAM software is an embedded application (MAESTRO) running on the Platform
Management Boards (PMB) and the other is an external application running on the Platform
Administration Processor (PAP) unit under Microsoft Windows.
You will use the secured PAM Web-based interface to operate, monitor, and configure the
server.
Once the Microsoft Windows software on the PAP unit has been booted, you will be
requested to supply a User Name and Password to open a Windows session. The session
MUST be started for the first time with the following factory default User Name and
Password:
User Name
Administrator
Password administrator
Important:
The factory default User Name and Password are used by the authorized Customer Service
Engineer during the setup procedure ONLY.
Factory default data must be replaced by Customer data once the system check has been
successfully completed. See Completing PAP Unit Configuration on page 2-24.