User`s guide

5-21
Tips and Features for Administrators
Configuring PAM Autocall Parameters
Autocall parameters are configured during the initial installation procedure, via the PAM
configuration setup Wizard. These parameters are used by PAM software to send event
messages (autocalls) to the Bull Support Center. As Customer Administrator, you may
check or uncheck the Enable Autocalls, Network id, and IP address boxes.
1. From the PAM Tree, click Configuration Tasks → Autocalls. The Autocalls
configuration page opens.
2. Check / uncheck the required boxes.
3. Click Save to confirm changes.
Figure 59. PAM Autocalls configuration page
Important:
Please notify your Customer Service Engineer if you modify PAM autocall
parameters.