Installation guide

2-29
Setup Procedure
10.Hot plug the data disks removed before launching the setup completion procedure. Once
setup is complete, the network is activated.
Note:
Repeat this procedure for each pre–installed Linux Redhat instance.
Linux SuSe SLES–8
Setup is completed via the Yast Control Center administration tool:
1. From the PAP unit enter the factory default User Name and Password:
User Name
root
Password root
followed by Enter.
2. Enter yast2 (graphical mode) or yast (non–graphical mode) to open the Yast Control
Center main page.
Note:
Use the <Tab> and <Arrow> keys to navigate through the menus.
3. Click Network/Basic → Network Card Configuration.
4. Select the required network card and click Configure.
5. From the Network Address Setup page, select the setup method and complete the
required fields with the data supplied by the Customer.
6. From the Details settings area, click Host name and name server. Complete the
required fields and click Next.
7. From the Details settings area, click Routing. Complete the required fields and click
Next to return to the Network Card Configuration page. Your network card is displayed
in the Already configured devices area.
8. Click Close to exit Yast Control Center.
9. Hot plug the data disks removed before launching the setup completion procedure. Once
setup is complete, the network is activated.
Note:
Repeat this procedure for each pre–installed Linux SuSE SLES–8 instance.