Installation guide

2-27
Setup Procedure
Completing Microsoft Windows Setup
Before proceeding to complete setup:
• Check Regional, Date/Time, and Time Zone settings.
• Check that the Customer has supplied the System and Networking data required to
complete setup and customize the system. See the Installation Setup Data tables in the
Read Me First document supplied on delivery.
Note:
SCSI Disk Racks
Unlock all DATA disks not used by the current Microsoft Windows instance. See Preparing
SCSI Disk Racks, on page 2-30.
• Check that the Microsoft Windows CD–ROM labeled “TO BE COMPLETED” is ready for
use.
• Check that the yellow sticker with the 25–character Microsoft Windows Product Key
required to complete setup is clearly visible inside the cabinet.
Power up the required system domain by repeating the actions described in Powering Up /
Down the Server Domain on page 2-19. The Microsoft Windows setup wizard is launched
automatically and guides the Customer and the Customer Service Engineer through the
setup completion procedure (approximately 30 minutes).
Warning:
Most of the options selected and validated during the setup sequence can be
modified.
However, special attention is to be paid when selecting and validating the Licensing
Mode (Per Seat / Per Server).
If selected and validated the “Per Server” Licensing Mode option CAN be modified.
If selected and validated, the “Per Seat” Licensing Mode CANNOT be modified.
Once setup is complete, Microsoft Windows shuts down, the system domain is rebooted
and the server configuration wizard is launched automatically. Server configuration is a
Customer–specific task and is not performed by the Customer Service Engineer during
installation.
Close the server configuration wizard. Once the system has been fully installed, the
Customer Administrator may launch this wizard to configure and manage Server Roles.
See the User’s Guide, 86 A1 89EF for recommended configuration tasks.
Note:
Repeat this procedure for each pre–installed Microsoft Windows instance.
Hot plug the data disks removed before launching the setup completion procedure.