Installation guide

2-26
Installation Guide
Configuring FTP Parameters for Autocalls
If the Customer’s maintenance contract includes the Autocall feature, configure FTP
parameters as follows:
1. Navigate to the PAM Web site (http://<papname>/pam).
See Launching PAM Software, on page 2-14.
2. Click Configuration → Autocalls.
3. Check the Enable Autocalls box.
4. Complete the fields with the following information:
Field
Explanation Value
Server name Remote Maintenance Center server IP address 123.145.167.189
Server port Default server port 21
Target directory Default server directory /autocall
Login Declared authorized user name X
Password Declared authorized user password X
Note:
The Network id and IP address boxes are only to be checked if authorized by the
Customer.
Important:
For enhanced confidentiality, the Customer Administrator is advised to supply a
temporary password for setup purposes and to change this password once setup is
complete.