Installation guide

2-13
Setup Procedure
Powering Up the Server
Once the PDU and CSS module cables have been connected to the power outlets at the
base of the cabinet, request the Customer to turn the two site power supply circuit breakers
ON in the following order:
a. PDU breaker.
b. CSS module breaker.
The Platform Administration Processor (PAP) unit automatically powers up and boots the
Microsoft Windows 2000 Server software. The Bull NovaScale Server Platform
Management Board (PMB) initializes to the standby mode as soon as power has been
applied and boots the embedded MAESTRO software.
Check that the green LED on the monitor is alight. If not, press the power button.
Note:
It may take several seconds for something to be displayed on the monitor. If the server does
not initialize to standby, or if an incident occurs, see Chapter 3. Troubleshooting.