Installation guide

2-12
Installation Guide
Connecting the Server to the Site Power Supply
Important:
Do NOT connect external data cables before powering up the server for the first time
on the Customer’s premises.
The Customer is responsible for ensuring that the electrical network is compliant with the
standards set out in the Site Preparation Guide, 86 A1 87EF.
CAUTION:
Only duly certified electricians may connect the server to the power supply, under the
Customer’s responsibility. The server is NOT equipped with a circuit breaker. The
circuit breakers referred to in this section are the SITE circuit breakers supplied by
the Customer.
Safety Recommendations
DANGER
An electrical outlet that is not correctly wired could place hazardous voltage on metal
parts of the server or the devices that attach to the server. It is the Customer’s
responsibility to ensure that the outlet is correctly wired and grounded to prevent an
electrical shock.
Use one hand, when possible, to connect or disconnect signal cables to prevent a
possible shock from touching two surfaces with different electrical potentials.
CAUTION:
The server is equipped with three–wire (phase/phase/ground) power cables for user
safety. Use this power cable with a properly grounded electrical outlet to avoid
electrical shock.
1. The server has more than one power supply cable. Follow procedures for removal
of power from the server when directed.
2. Energy hazard, remove all jewelry before servicing.
3. Check that the dedicated power supply circuit breakers are OFF.