Installation guide

1-7
Delivery
Unloading the Cabinet
Important:
To ensure safe handling, doors and side covers must be removed before unloading
the cabinet from the pallet. See Removing the Front Door, on page 1-15, Removing
the Rear Door, on page 1-17, and Removing Side Covers, on page 1-19.
Installing the Unloading Rail / Ramp Assembly
Tools Required:
• 17 mm hex wrench
1. Remove the rail fixtures from their packing.
A
B
C
Figure 5. Rail / ramp assembly
2. Assemble the two rails and tighten the four bolts with the 17 mm hex wrench (A).
3. Insert the pin at the top of each rail into the small holes on both sides of the pallet (B).
4. Insert the pin at the bottom of each rail into the small holes on both sides of the ramp
(C).