Specifications

4-4
Site Preparation Guide
For PDU/UPS equipped with IEC 60309 plugs.
1. Check that the power supply cable is not live with the multimeter.
2. Carefully guide the power supply cable through the cable inlet at the base of the cabinet.
3. Check that the power supply cable is long enough.
4. Unscrew the base of the socket (A), insert the cable through the socket base (B), and wire
to the socket head, as shown in Figure 14.
Figure 14. PDU/UPS Power socket
5. Screw the socket base back to the socket head (C).
6. Check for < 0.1 ohm resistance between the grounding pin on the power cable plug and
the metal frame with the multimeter.
7. Connect the power supply cable socket to the power cable plug.
8. Use velcro fasteners to secure the cable into place along the cabinet frame.