System information

C-22
ESCALA T610, PL 400T et PL 600T Guide de l’utilisateur système
# E0=echo disabled
ignore ”0\r” or ”OK\r\n” timeout 2 # Ignore modem response.
send ”AT#F0*Q2S8=6\r” # Trellis modulation disabled
# Retrain with adaptive rate
# Set ,=6second
expect ”0\r” or ”OK\r\n” timeout 2 # Confirm commands successful
send ”ATV0X0S0=0\r” # Numeric response code
# AT compatible messages
# Auto–Answer disabled
expect ”0\r” or ”OK\r\n” timeout 2 # Confirm commands successful.
done
connect: send ”ATDT%N\r” # Tone dialing command.
# %N from Call Home setup.
expect ”1\r” busy ”7\r” timeout 60 # Expect a connection response.
done
retry: send ”A/” # Repeat the previous command.
expect ”1\r” busy ”7\r” timeout 60 # Expect a connection response.
done
disconnect:
delay 2 # Separate from previous data.
send ”+++” # Assure command mode.
delay 2 # Allow mode switching delay.
send ”ATH0\r” # Set modem switch–hook down
# (i.e., hang up).
ignore ”0\r” or ”OK\r” timeout 2 # Ignore modem response.
send ”ATE0Q1\r” # Initialize modem: Echo OFF,
# Disable responses.
ignore ”0\r” timeout 1
done
condin: send ”AT&F*E0E0\r” # Reset to factory defaults.
# *E0=data compression disabled
# E0=echo disabled
ignore ”0\r” or ”OK\r\n” timeout 2 # Ignore modem response.
send ”AT#F0*Q2\r” # Trellis modulation disabled
# Retrain with adaptive rate
expect ”0\r” or ”OK\r\n” timeout 2 # Confirm commands successful
send ”ATV0X0S0=2\r” # Numeric response code
# AT compatible messages
# Answer on 2nd ring
expect ”0\r” timeout 2 # Confirm commands successful.
done
waitcall: ignore ”2\r” timeout 1 # Ignore first ring.
expect ”2\r” timeout 10 # Pick up second ring
# or timeout.
# Expect a connection response.
expect ”1\r” timeout 60
done
page: send ”ATD%N,%R\r” # %N = pager call center number
# commas=6sec wait time to
# enter paging number.
# %R = return number
expect ”0\r” or ”3\r” timeout 30 # Confirm successful command.
delay 2 # Wait before hanging up.
send ”+++” # Assure command mode.