System information

C-16
ESCALA T610, PL 400T et PL 600T Guide de l’utilisateur système
send ”AT&C1&D2&R1\r” # Detect carrier and DTR,
# Ignore RTS.
expect ”0\r” timeout 2 # Confirm command successful.
done
waitcall: ignore ”2\r” timeout 1 # Ignore first ring.
expect ”2\r” timeout 10 # Pick up second ring
# or timeout.
# Expect a connection response.
expect ”16\r” or ”15\r” or ”14\r” or ”12\r” or ”10\r” or ”5\r” or ”1\r”
timeout 60
done
page: send ”ATDT%N,,,,%R;\r” # %N = pager call center number
# Add enough commas to wait for
# time to enter paging number.
# %R = paging number
# Confirm successful command.
expect ”0\r” timeout 60
delay 2 # Wait before hanging up.
send ”ATH0T\r” # Hang up.
expect ”0\r” timeout 2 # Confirm successful command.
done
ripo: send ”AT&F0Q0T\r” # Reset modem. Select profile 0
ignore ”0\r” or ”OK\r\n” timeout 2 # Ignore modem response.
send ”ATE0T\r” # Initialize modem: Echo OFF,
expect ”0\r” or ”OK\r\n” timeout 2 # Enable responses (Numeric),
send ”ATQ0V0X0T\r” # Limit response codes.
expect ”0\r” timeout 2 # Confirm commands successful.
send ”ATS0=0\r” # Set AutoAnswer OFF
expect ”0\r” timeout 2 # Confirm command successful.
send ”AT&C1&D2&R1\r” # Detect carrier and DTR,
# Ignore RTS.
expect ”0\r” timeout 2 # Confirm command successful.
done # RI Power On enabled.
error: # Handle unexpected modem
# responses.
expect ”8\r” or ”7\r” or ”6\r” or ”4\r” or ”3\r”
delay 2
done
Fichier d’exemple modem_f1.cfg
#
# COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F1
#
# FUNCTIONS: Modem configuration file for many recent Hayes* compatible modems.
# This example uses the AT&F1 reset command to choose the factory defaults.
# This set up is for modems with extended (&) commands and which do not work
# properly with setup F0. For early vintage modems, setup Z or Z0 is
# recommended.
#
# * Trademark of Hayes Microcomputer Products, Inc.
#