System information

C-15
Configurations de modems
# &C1 Detect CD &D2 Respond to DTR (often the default)
# &R1 Ignore RTS (CTS)
#
# %N Call–Out phone number %P Paging phone number
# %S Modem speed (available to users)
#
# Following are common responses from a wide range of modems:
# 16, 15, 12, 10, 5 and 1 are connection responses. Add others as required.
# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; 0=OK
#
# PROGRAMMING NOTE: No blanks between double quote marks (”).
condout: send ”AT&F0Q0T\r” # Reset modem. Select profile 0
ignore ”0\r” or ”OK\r\n” timeout 2 # Ignore modem response.
send ”ATE0T\r” # Initialize modem: Echo OFF,
expect ”0\r” or ”OK\r\n” timeout 2 # Enable responses (Numeric),
send ”ATQ0V0X0T\r” # Limit response codes.
expect ”0\r” timeout 2 # Confirm commands successful.
send ”ATS0=0\r” # Set AutoAnswer OFF
expect ”0\r” timeout 2 # Confirm command successful.
send ”AT&C1&D2&R1\r” # Detect carrier and DTR,
# Ignore RTS.
expect ”0\r” timeout 2 # Confirm command successful.
done
connect: send ”ATDT%N\r” # Tone dialing command.
# %N from Call Home setup.
# Expect a connection response.
expect ”16\r” or ”15\r” or ”14\r” or ”12\r” or ”10\r” or ”5\r” or ”1\r” busy ”7\r”
timeout 60
done
retry: send ”A/” # Repeat the previous command.
# Expect a connection response.
expect ”16\r” or ”15\r” or ”14\r” or ”12\r” or ”10\r” or ”5\r” or ”1\r” busy ”7\r”
timeout 60
done
disconnect:
delay 2 # Separate from previous data.
send ”+++” # Assure command mode.
delay 2 # Allow mode switching delay.
send ”ATH0T\r” # Set modem switch–hook down
# (i.e., hang up).
ignore ”0\r” or ”OK\r” timeout 2 # Ignore modem response.
send ”ATE0Q1\r” # Initialize modem: Echo OFF,
# Disable responses.
ignore ”0\r” timeout 1
done
condin: send ”AT&F0Q0T\r” # Reset modem. Select profile 0
ignore ”0\r” or ”OK\r\n” timeout 2 # Ignore modem response.
send ”ATE0T\r” # Initialize modem: Echo OFF,
expect ”0\r” or ”OK\r\n” timeout 2 # Enable responses (Numeric),
send ”ATQ0V0X0T\r” # Limit response codes.
expect ”0\r” timeout 2 # Confirm commands successful.
send ”ATS0=2\r” # Set AutoAnswer ON
expect ”0\r” timeout 2 # Confirm command successful.