System information

C-14
ESCALA T610, PL 400T et PL 600T Guide de l’utilisateur système
ripo: send ”AT&FQ0T\r” # Reset to factory defaults.
ignore ”0\r” or ”OK\r\n” timeout 2 # Ignore modem response.
send ”ATE0T\r” # Initialize modem: Echo OFF,
expect ”0\r” or ”OK\r\n” timeout 2 # Enable responses (Numeric),
send ”ATQ0V0X0T\r” # Limit response codes.
expect ”0\r” timeout 2 # Confirm commands successful.
send ”ATS0=0\r” # Set AutoAnswer OFF
expect ”0\r” timeout 2 # Confirm command successful.
send ”AT&C1&D2\r” # Detect carrier and DTR.
expect ”0\r” timeout 2 # Confirm command successful.
done # RI Power On enabled.
error: # Handle unexpected modem
# responses.
expect ”8\r” or ”7\r” or ”6\r” or ”4\r” or ”3\r”
delay 2
done
Fichier d’exemple modem_f0.cfg
#
# COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F0
#
# FUNCTIONS: Modem configuration file for many recent Hayes* compatible modems.
# This example uses the AT&F0 reset command to choose the factory defaults.
# This set up is preferred for modems with extended (&) commands. For early
# vintage modems, setup Z or Z0 is recommended. If your modem responds to
# the extended (&) commands and to factory default choices (&Fn), but doesn’t
# work properly with this setup file, setup F1 is recommended.
#
# * Trademark of Hayes Microcomputer Products, Inc.
#
# (C) COPYRIGHT International Business Machines Corp. 1996
# All Rights Reserved
# Licensed Materials – Property of IBM
#
# US Government Users Restricted Rights – Use, duplication or
# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
#
#
# If the modem has configuration switches, they should be set to the
# factory default settings.
ICDelay 1
DefaultTO 10
CallDelay 120
# AT Attention Code , Inserts delay in dialing commands
# &F0 Reset. Restore profile 0 Q0 Turn on responses
# E0 Turn echo off Q1 Turn off responses
# V0 Use numeric responses S0=0 Automatic answer inhibit
# +++ Escape to command mode S0=2 Answer on second ring
# H0 Hang–up X0=0 Limit modem response codes
# T = Tone mode. When used as T\r, it is a
# no op to maintain program synchronization
# when modem may/will echo the commands.
#