System information

C-13
Configurations de modems
done
connect: send ”ATDT%N\r” # Tone dialing command.
# %N from Call Home setup.
# Expect a connection response.
expect ”16\r” or ”15\r” or ”14\r” or ”12\r” or ”10\r” or ”5\r” or ”1\r” busy ”7\r”
timeout 60
done
retry: send ”A/” # Repeat the previous command.
# Expect a connection response.
expect ”16\r” or ”15\r” or ”14\r” or ”12\r” or ”10\r” or ”5\r” or ”1\r” busy ”7\r”
timeout 60
done
disconnect:
delay 2 # Separate from previous data.
send ”+++” # Assure command mode.
delay 2 # Allow mode switching delay.
send ”ATH0T\r” # Set modem switch–hook down
# (i.e., hang up).
ignore ”0\r” or ”OK\r” timeout 2 # Ignore modem response.
send ”ATE0Q1\r” # Initialize modem: Echo OFF,
# Disable responses.
ignore ”0\r” timeout 1
done
condin: send ”AT&FQ0T\r” # Reset to factory defaults.
ignore ”0\r” or ”OK\r\n” timeout 2 # Ignore modem response.
send ”ATE0T\r” # Initialize modem: Echo OFF,
expect ”0\r” or ”OK\r\n” timeout 2 # Enable responses (Numeric),
send ”ATQ0V0X0T\r” # Limit response codes.
expect ”0\r” timeout 2 # Confirm commands successful.
send ”ATS0=2\r” # Set AutoAnswer ON
expect ”0\r” timeout 2 # Confirm command successful.
send ”AT&C1&D2\r” # Detect carrier and DTR.
expect ”0\r” timeout 2 # Confirm command successful.
done
waitcall: ignore ”2\r” timeout 1 # Ignore first ring.
expect ”2\r” timeout 10 # Pick up second ring
# or timeout.
# Expect a connection response.
expect ”16\r” or ”15\r” or ”14\r” or ”12\r” or ”10\r” or ”5\r” or ”1\r”
timeout 60
done
page: send ”ATDT%N,,,,%R;\r” # %N = pager call center number
# Add enough commas to wait for
# time to enter paging number.
# %R = paging number
# Confirm successful command.
expect ”0\r” timeout 60
delay 2 # Wait before hanging up.
send ”ATH0T\r” # Hang up.
expect ”0\r” timeout 2 # Confirm successful command.
done