System information

C-10
ESCALA T610, PL 400T et PL 600T Guide de lutilisateur système
ICDelay 1
DefaultTO 10
CallDelay 120
# AT Attention Code , Inserts delay in dialing commands
# Z0 Reset. Restore Profile 0 Q0 Turn on responses
# E0 Turn echo off Q1 Turn off responses
# V0 Use numeric responses S0=0 Automatic answer inhibit
# +++ Escape to command mode S0=2 Answer on second ring
# H0 Hangup X0=0 Limit modem response codes
# T = Tone mode. When used as T\r, it is a
# no op to maintain program synchronization
# when modem may/will echo the commands.
#
# %N CallOut phone number %P Paging phone number
# %S Modem speed (available to users)
#
# Following are common responses from a wide range of modems:
# 16, 15, 12, 10, 5 and 1 are connection responses. Add others as required.
# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; 0=OK
#
# PROGRAMMING NOTE: No blanks between double quote marks ().
condout: send ATZ0Q0T\r # Reset modem. Select profile 0
ignore 0\r or OK\r\n timeout 2 # Ignore modem response.
send ATE0T\r # Initialize modem: Echo OFF,
expect 0\r or OK\r\n timeout 2 # Enable responses (Numeric),
send ATQ0V0X0T\r # Limit response codes.
expect 0\r timeout 2 # Confirm commands successful.
send ATS0=0\r # Set AutoAnswer OFF
expect 0\r timeout 2 # Confirm command successful.
done
connect: send ATDT%N\r # Tone dialing command.
# %N from Call Home setup.
# Expect a connection response.
expect 16\r or 15\r or 14\r or 12\r or 10\r or 5\r or 1\r busy 7\r
timeout 60
done
retry: send A/ # Repeat the previous command.
# Expect a connection response.
expect 16\r or 15\r or 14\r or 12\r or 10\r or 5\r or 1\r busy 7\r
timeout 60
done
disconnect:
delay 2 # Separate from previous data.
send +++ # Assure command mode.
delay 2 # Allow mode switching delay.
send ATH0T\r # Set modem switchhook down
# (i.e., hang up).
ignore 0\r or OK\r timeout 2 # Ignore modem response.
send ATE0Q1\r # Initialize modem: Echo OFF,
# Disable responses.
ignore 0\r timeout 1
done