User`s guide

8-6
ESCALA T610 and PL 600T User’s Guide
Step 14
The diagnostics produced an SRN for this problem.
1. Record the SRN.
2. Report the SRN to the service organization.
3. STOP. You have completed these procedures.
Step 15
When you are loading the Standalone Diagnostics, the attributes for the terminal must be
set to match the defaults of the diagnostic programs. The ASCII terminal must be attached
to serial port 1 on the system unit.
Are you going to load Standalone Diagnostics and run them from a ASCII terminal?
NO Go to ”Step 16”.
YES Go to ”Running the Diagnostics from a TTY Terminal” on page 5-3 and be
sure your terminal attributes are set to work with the diagnostic programs.
Return to ”Step 16” when you finish checking the attributes. Record any
settings that are changed.
Step 16
This step loads the Standalone Diagnostics. If you are unable to load the diagnostics, go to
”Step 7”.
1. Turn the power on.
2. Insert the diagnostic CD–ROM into the CD–ROM drive.
3. When the keyboard indicator appears, press the numeric 5 key on the keyboard to
indicate that diagnostics are to be loaded.
4. Enter any requested passwords.
5. Follow any instructions to select a console.
Did the Diagnostics Operating Instructions display without any obvious display
problem?
NO Go to ”Step 7”.
YES Go to ”Step 9”.
Step 17
The diagnostics did not find a hardware problem. If you still have a problem, contact your
software support center.