User`s guide

3-19
Using the Service Processor
• Call–Out Test Menu tests the configuration after the modem is installed and configured.
In order for this test to execute successfully, at least one of the following numbers must
be assigned:
– Service center telephone number
– Customer administration center telephone number
– Digital pager telephone number
Modem Configuration Menu
The first two lines of the Modem Configuration Menu are status lines showing the current
selections. Selections are made in the two sections labeled Modem Ports and Modem
Configuration File Name. Select the serial port that you want to activate and then select the
modem configuration file for the modem on the port. If you want to set up all of the serial
ports with modems, make your selections one port at a time.
Note: Modem configuration is only supported on serial port 1 (S1) and serial port 2 (S2).
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
| |
| Modem Configuration Menu |
| |
| Port 1 Modem Configuration File Name: |
| Port 2 Modem Configuration File Name: |
| |
|To make changes, First select the port and then the configuration file |
|name |
| |
|Modem Ports: |
| 1. Serial port 1 |
| 2. Serial port 2 |
| |
|Modem Configuration File Name: |
| 5. none 9. modem_z_sp |
| 6. modem_f_sp 10. modem_m1_sp |
| 7. modem_f0_sp 11. modem_m0_sp |
| 8. modem_f1_sp 12. modem_m1_sp |
| |
| 30. Save configuration to NVRAM and Configure modem |
| 98. Return to Previous Menu |
| |
| 0 |
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
For information on choosing a modem configuration file, see ”Sample Modem Configuration
Files” on page C-6, and ”Transfer of a Modem Session” on page C-4.
Serial Port Selection Menu
This menu allows you to enable and/or disable the call–in and call–out functions of each
serial port in any combination.
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
| |
| Serial Port Selection Menu |
| |
| 1. Serial Port 1 Call–Out: 3. Serial Port 1 Call–In: |
| Currently Disabled Currently Disabled |
| |
| 2. Serial Port 2 Call–Out: 4. Serial Port 2 Call–In: |
| Currently Disabled Currently Disabled |
| |
| 98. Return to Previous Menu |
| |
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
Call–in and ring indicate power–on cannot be enabled at the same time. If ring indicate
power on is already enabled and you try to enable call–in, a message prompts you for
confirmation. Refer to the message displayed on the screen.