User`s guide
3-9
Using the Service Processor
System Power Control Menu
This menu is used to set power control options. Other menus that control boot options are
available here:
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
| |
| SYSTEM POWER CONTROL MENU |
| |
| 1. Enable/Disable Unattended Start Mode: |
| Currently Enabled |
| |
| 2. Ring Indicate Power–On Menu |
| |
| 3. Reboot/Restart Policy Setup Menu |
| |
| 4. Power–On System |
| |
| 5. Power–Off System |
| |
| 6. Enable/Disable Fast System Boot |
| Currently Enabled |
| |
| 7. Boot Mode Menu |
| |
| 98. Return to Previous Menu |
| |
| 99. Exit from Menus |
| |
| 1 |
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
• Enable/Disable Unattended Start Mode
Use this option to instruct the service processor to restore the power–state of the server
after a temporary power failure. Unattended Start Mode can also be set through the
System Management Services (SMS) Menus. It is intended to be used on servers that
require automatic power–on after a power failure. For more information, see ”System
Power–On Methods” on page 3-24.
• Ring Indicate Power–On Menu
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
| |
| RING INDICATE POWER–ON MENU |
| |
| 1. Ring indicate power–on : |
| Currently Enabled |
| |
| 2. Number of rings: |
| Currently 3 |
| |
| 30. Refresh Modem Settings |
| |
| 98. Return to Previous Menu |
| |
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
Ring indicate is enabled by default on both serial port 1 (S1) and serial port 2 (S2). When
ring indicate power on is enabled, call–in is disabled.
If ring indicate power–on is enabled and call–in is already enabled, you will be asked to
confirm your choice. Refer to the message displayed on your screen.
If the ring indicate power–on setting is changed, you must select option 30, Refresh
Modem Settings to update the modem settings. If option 30, Refresh Modem Setting is
selected, and the modem(s) have not been configured, you will be asked to configure the
modems first. See ”Call–In/Call–Out Setup Menu” on page 3-18 for information on
configuring modems.
Option 2 is used to set the number of rings.