Installation guide

3-48
ESCALA T610 and PL 600T Installation Guide
Replacing Covers
1. To replace the side covers, do the following:
a. Insert the tabs on the side cover into the slots on the system unit.
b. Slide the cover toward the front of the system unit until the rear corner of the cover
contacts the rear of the system unit.
c. Secure the rear of the cover with the screws removed earlier.
2. To replace the front cover, align the tabs on the front cover with the slots of the extension
on the bottom of the system unit. Push in the front cover at the top until it is secure.
3. To replace the rear cover, align the tabs on the side covers with the slots on the rear
cover, and slide the cover down until it latches into place.
4. If the power cord is not plugged into the wall outlet, plug it in now.
5. If the system is not operating, wait until OK appears on the operator panel. Then press
the power button on the operator panel once to start the system.
If you have installed new adapters or devices, you might need to refer to the AIX System
Management Guide: Operating System and Devices to configure the new adapter or device.
This publication is also contained on the Hypertext Library CD. The documentation
information is made accessible by loading the documentation CD onto the hard disk or by
mounting the CD in the CD–ROM drive.