Installation guide

3-44
ESCALA T610 and PL 600T Installation Guide
5. The drive you are installing attaches to the same blank cover bracket that you removed
in the previous step. Perform the following steps to remove the blank cover from the
bracket and install the bracket onto the new drive.
a. Remove the three screws from the blank cover bracket.
b. Separate the blank cover from the bracket.
c. Install the new drive into the bracket as shown in the following figure. To secure the
drive, use the three screws that you removed earlier.
6. Set the SCSI address jumpers at the rear of the drive to the correct address. Refer to the
documentation provided with your drive for details on setting the SCSI address.
7. Look into the media bay and locate the two SCSI and power cables used to attach the
drive to the system unit. Connect the cables from the system to the rear of the drive.
8. Ensure that the locking knobs are pulled to the out position, and install the drive in the
system unit by sliding it into the optional media bay until the locking knobs contact the
frame of the system unit.
9. Push each locking knob until you feel it lock into position.
10.If you have other options to install, refer to ”Option List” on page 3-3.
11.If you do not have other options to install, replace the system unit covers as described in
”Replacing Covers” on page 3-48.