Installation guide

3-43
Installing Options
Installing Non–Hot–Plug Media Drives
The section helps you install non hot–plug drives in the optional media position of the
system.
Installing a Drive in the Optional Media Position
CAUTION:
A class 3 laser is contained in the device. Do not attempt to operate the drive while it
is disassembled. Do not attempt to open the covers of the drive as it is not
serviceable and is to be replaced as a unit.
1. If you have not already done so, shut down the system as described in ”Stopping the
System Unit” on page 3-2.
2. If you have not already done so, unplug the system unit power cable from the electrical
outlet.
3. If you have not already done so, remove the front and right covers as described in
”Removing the Covers” on page 3-4.
4. Pull the locking knob on the media bay blank cover bracket and remove it by pulling it
straight out from the system unit.