Installation guide

3-39
Installing Options
10.Slide the disk drive cage all the way into the system unit until it contacts the front frame.
11.Install six screws to hold the disk drive cage in the system unit. There are four screws in
the front of the unit and two inside the back (one at the upper left, one at the lower right).
Use the long nut driver provided with the disk drive cage to install the screws.
12.Install the disk drives in the disk drive cage you just installed. Refer to ”Installing
Hot–Plug SCSI Disk Drives” on page 3-27.
13.If you have other options to install, refer to ”Option List” on page 3-3.
14.If you do not have other options to install, replace the covers as described in ”Replacing
Covers” on page 3-48.
SCSI and SSA Cabling Configurations
The figures in this section show the cabling for many of the configurations available on this
system. Locate the figure here that most closely matches your system’s drive configuration,
and connect your cables to match the figure.
Note: The two six–position SCSI disk drive bays must be connected to separate SCSI
buses.
Two–Position SCSI Disk Drive Bay Cabling
View of Right Side
View of Left Side
Four Drop
SCSI Cable
Internal
SCSI Cable