Installation guide

3-38
ESCALA T610 and PL 600T Installation Guide
7. Position the cables so they can be guided through the holes in the rear of the system unit
bay and slide the disk drive cage halfway into the system unit.
8. Connect the power cables to the power connectors, which are located on the system
board behind the enclosure. Refer to the following figure, which shows the system board
from the right side of the machine with the right cover removed.
1
2
3
4
5
6
8
7
9
1
I
2
C to Six–Position Disk Drive Bay 1 (DB1) 6 I
2
C to Six–Position Disk Drive Bay 2 (DB2)
2 Power 2 to Six–Position Disk Drive Bay 1
(DB1)
7 Power to Diskette Drive
3 Power 1 to Six–Position Disk Drive Bay 1
(DB1)
8 Power to Media Drive Bay
4 Power 1 to Six–Position Disk Drive Bay 2
(DB2)
9 Power 1 to Two–Position Disk Drive Bay 3
(DB3)
5 Power 2 to Six–Postion Disk Drive Bay 2
(DB2)
9. Connect the signal cables. Refer to ”SCSI and SSA Cabling Configurations” on page
3-39 and follow the cabling diagram for your system configuration.