Installation guide

3-36
ESCALA T610 and PL 600T Installation Guide
8. Install the screws to hold the two–position cage in position.
a. Install two screws in the inside rear of the cage.
b. Install two screws in the front of the cage (upper left and the lower right).
9. Install the disk drives, see ”Installing a SCSI Disk Drive in the Two–Position Disk Drive
Bay” on page 3-24.
10.Install the bay cover with the two remaining screws.
11.If you have other options to install, refer to ”Option List” on page 3-3.
12.If you do not have other options to install, replace the system unit covers as described in
”Replacing Covers” on page 3-48.
13.Turn on the power.
Installing Six–Position SCSI or SSA Disk Drive Bays
1. If you have not already done so, shut down the system as described in ”Stopping the
System Unit” on page 3-2.
2. If you have not already done so, unplug the system unit power cable from the electrical
outlet.
3. If you have not already done so, remove the covers, as described in ”Removing the
Covers” on page 3-4.
4. Locate the position where you are installing the disk drive bay, and remove the screws to
remove the blank cover from that position.
5. If you are installing a second disk drive bay, and an adapter to connect the disk drive bay
to the system, install the adapter first. Refer to ”Installing Adapter Cards” on page 3-8.
6. Locate the new disk drive bay cage and connect the power cables. Then connect the
signal cables and the I
2
cables to the backplane. See the figures on the following page
for cable positions.