Installation guide

3-34
ESCALA T610 and PL 600T Installation Guide
Installing Internal Disk Drive Bays
The system has positions for three disk drive bays, which are available for installing
additional disk drives. Because there are many configurations possible for each system, this
procedure instructs you how to install the disk drive bay hardware and then refers you to
cabling diagrams when appropriate for the type of bay you are installing. The following
figure shows the system with the front cover removed and the disk drive bays are identified.
Note: All disk drive slots must have a disk drive or filler installed.
DB2
DB3
DB1
D
0
1
D
0
7
D
0
3
D
0
9
D
0
5
D
1
1
D
0
2
D
0
8
D
0
4
D
1
0
D
0
6
D
1
2
D13
D14
If you are installing:
• A two–position SCSI disk drive bay, continue with ”Installing a Two–Position SCSI Disk
Drive Bay” on page 3-34.
• A six–position SCSI or SSA hot–plug disk drive bay, go to ”Installing Six–Position SCSI or
SSA Disk Drive Bays” on page 3-36.
Installing a Two–Position SCSI Disk Drive Bay
Use this following procedure to install a two–position SCSI disk drive bay:
1. If you have not already done so, shut down the system as described in ”Stopping the
System Unit” on page 3-2.
2. Unplug the power cord from the electrical outlet.
3. If you have not already done so, remove the front and right side covers as described in
”Removing the Covers” on page 3-4.
4. Remove the cover from the position for the disk drive bay.