Installation guide

3-32
ESCALA T610 and PL 600T Installation Guide
11.Select Install/Configure Devices Added After IPL and press Enter. Follow the
instructions on the screen. Successful configuration is indicated by the OK message
displayed next to the Command field at the top of the screen.
12.Press F10 to exit smitty.
13.If you have other options to install, refer to ”Option List” on page 3-3.
14.If you do not have other options to install, replace the front cover as described in
”Replacing Covers” on page 3-48.
15.Go to ”Configuring and Deconfiguring SSA Hot–Swap Disk Drives” on page 3-33 to
configure the drive for use with your operating system.
Removing Hot–Plug SSA Disk Drives
Review the information in ”Disk Drive Options” on page 3-22 before removing a disk drive.
1. Back up the information from the disk drive to another drive.
2. Deconfigure the drive you are removing from the system. Go to ”Configuring and
Deconfiguring SSA Hot–Swap Disk Drives” on page 3-33 to deconfigure the drive from
your operating system.
3. If you have not already done so, remove the front cover as described in ”Removing the
Covers” on page 3-4.
4. Remove the disk drive bay cover from the disk drive bay.
5. Log in as root user.
6. At the command line, type smitty.
7. Select Devices.
8. Select SSA Disks.
9. Select SSA Physical Disks.
10.Select Identify an SSA Physical Disk.
11.Select the disk you want to remove from the list.