Installation guide

3-28
ESCALA T610 and PL 600T Installation Guide
7. Repeat this process for all the drives you are installing in this bay. Then replace the
cover on the bay.
8. Log in as root user.
9. At the command line, type smitty.
10.Select Devices.
11.Select Install/Configure Devices Added After IPL and press Enter. Follow the
instructions on the screen. Successful configuration is indicated by the OK message
displayed next to the Command field at the top of the screen.
12.Press F10 to exit smitty.
13.If you have other options to install, refer to ”Option List” on page 3-3.
14.If you do not have other options to install, replace the front cover as described in
”Replacing Covers” on page 3-48.
15.Go to ”Configuring and Deconfiguring SCSI Hot–Swap Disk Drives” on page 3-30 to
configure the drive for use with your operating system.
Removing Hot–Plug SCSI Disk Drives
Note: Disk drives in the two–position drive bay cannot be removed with the power on. See
”Removing a SCSI Disk Drive from the Two–Position Disk Drive Bay” on page 3-25.
Review the information in ”Disk Drive Options” on page 3-22 before removing a disk drive.
1. Back up the information from the disk drive to another drive.
2. Deconfigure the drive you are removing from the system. See ”Deconfiguring Drives” on
page 3-30.
3. If you have not already done so, remove the front cover as described in ”Removing the
Covers” on page 3-4.
4. Remove the disk drive bay cover from the disk drive bay.
5. Log in as root user.
6. At the command line, type smitty.