Installation guide

3-25
Installing Options
6. Slide the disk drive into the bay as shown in the following figure.
7. If you have other options to install, refer to ”Option List” on page 3-3.
8. If you do not have other options to install, replace the two–position SCSI disk drive bay
cover.
9. Replace the system unit covers as described in ”Replacing Covers” on page 3-48.
Removing a SCSI Disk Drive from the Two–Position Disk Drive Bay
This section helps you remove non hot–plug drives from the two–position SCSI disk drive
bay. Refer to the “Preinstallation Considerations” on page 3-23 before proceeding.
1. If you have not already done so, shut down the system as described in ”Stopping the
System Unit” on page 3-2.
2. If you have not already done so, unplug the system unit power cable from the electrical
outlet.
3. If you have not already done so, remove the front and right covers as described in
”Removing the Covers” on page 3-4.