Installation guide

3-24
ESCALA T610 and PL 600T Installation Guide
Installing a SCSI Disk Drive in the Two–Position Disk Drive Bay
The section helps you install non hot–plug drives in the two–position SCSI disk drive bay.
1. If you have not already done so, shut down the system as described in ”Stopping the
System Unit” on page 3-2.
2. If you have not already done so, unplug the system unit power cable from the electrical
outlet.
3. If you have not already done so, remove the front and right covers as described in
”Removing the Covers” on page 3-4.
4. Remove the two screws (lower left and upper right) that hold the cover onto the
two–position SCSI drive bay and remove the cover
5. Remove the disk drive from its protective packaging and open the drive latch handle.