Installation guide

3-21
Installing Options
4. Remove the processor and memory card cover as described in ”Removing Processor
and Memory Card Cover” on page 3-6.
5. The card is secured in place with camming latches at each end. Open the card latches
by rotating them out until the card is pulled out of the connector on the system board.
Attention To prevent damage to the card and to the card connectors, open the latches
at the same time. You must install either a memory card or a blank memory card in each
memory card slot. Do not operate the system with any empty memory card slots.
6. If you have other options to install, refer to ”Option List” on page 3-3.
7. If you do not have other options to install, replace the processor and memory card cover
as described in ”Replacing Processor and Memory Card Cover” on page 3-6.
8. Replace the system unit covers as described in ”Replacing Covers” on page 3-48.