Installation guide

3-20
ESCALA T610 and PL 600T Installation Guide
6. With one hand, touch any metal surface of the chassis to minimize static electrical
charges, and then pick up the memory or processor card.
7. Open the camming latches.
8. Place the card onto the card guide rails. The memory DIMMs, if present, should face
down.
9. Push the card into the system unit until you feel it stop. The card should be far enough
into the system unit so that the camming latches engage.
10.Close the camming latches to secure the card into the connector.
Attention: To prevent damage to the card and to the card connectors, close both
camming latches at the same time.
11.If you have other options to install, refer to ”Option List” on page 3-3.
12.If you do not have other options to install, replace the processor and memory card cover
as described in ”Replacing Processor and Memory Card Cover” on page 3-6.
13.Replace the system unit covers as described in ”Replacing Covers” on page 3-48.
Removing a Memory Card or One–Way Processor Card
1. If you have not already done so, shut down the system as described in ”Stopping the
System Unit” on page 3-2.
2. If you have not already done so, unplug the system unit power cable from the electrical
outlet.
3. If you have not already done so, remove the covers as described in ”Removing the
Covers” on page 3-4.