Installation guide

3-18
ESCALA T610 and PL 600T Installation Guide
7. Locate the memory DIMM connector on the card, and remove the DIMM or dummy
memory DIMM from the connector by pushing the tabs out on the memory connector.
Push Locking Tabs
Out to Release Memory
Module
1
2
1
8. Align the slots in the memory DIMM with the tabs on the connector. (The DIMM will go
only in one direction.) Insert the memory DIMM by firmly pressing the DIMM into the
connector. The locking tabs on each end of the connector should secure the DIMM into
position.
Locking Tabs
9. Install the memory card in the system unit. See ”Installing a Memory Card or a One–Way
Processor Card” on page 3-19 for more information.
10.If you have other options to install, refer to ”Option List” on page 3-3.
11.If you do not have other options to install, replace the processor and memory card cover
as described in ”Replacing Processor and Memory Card Cover” on page 3-6.
12.Replace the system unit covers as described in ”Replacing Covers” on page 3-48.