Installation guide

3-13
Installing Options
15.Turn the locking latch and lift the plastic stop for the adapter. Some full–length adapter
cards can be removed by rotating the blue adapter latch on the right end of the adapter
divider clockwise.
16.Carefully grasp the adapter by the edges and pull it straight out from the system board.
Store the adapter in a safe place.
17.If you are not replacing the adapter with an identical adapter, place a blank slot cover in
the adapter slot and then lower the plastic stop over the adapter bracket. Otherwise,
insert the new adapter and rotate the locking latch clockwise until it clicks into the locked
position.
18.Continue to follow the screen instructions until you receive a message that the adapter
removal is successful. Successful removal is indicated by the OK message displayed
next to the Command field at the top of the screen.
19.Press F10 to exit the Hot–Plug Manager.
20.If you have added, removed, or replaced any adapters, run the diag –a command. If the
system responds with a menu or prompt, follow the instructions to complete the device
configuration.
21.If you have options to install, refer to ”Option List” on page 3-3.
22.If you do not have options to install, replace the system unit covers as described in
”Replacing Covers” on page 3-48.